In nearly all cases, most individuals spend quite a bit of money purchasing their forklift. Therefore, it is very essential to take good care of it in order to protect your investment well into the long run. It is really a great idea to know the procedures that are carried out in the maintenance and care of this piece of machine.
One of the best ways to tell how good the engine is performing is by starting the lift truck up and listening closely to see how it runs. Like for example, if there are any misses or knocks, the machine is defective and this must raise several issues. In addition listen closely for any squealing sounds that come from the belts because these noises would provide you with a lot of information.
When doing maintenance, some of the main components you would have to pay attention to comprise the safety warning devices, horn, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals must be cleaned after the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery has to be inspected so as to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle needs to be carried out. If there is a grease fitting on the axle make certain to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. Then, inspect each and every other component of the machine including the wheels. If any kind of problem or fault is detected, be sure to address it immediately so as to make sure the machine is working at its safest and optimum levels.