Change a Propane Tank
Propane powered forklifts are normally used in warehouses. The forklift is made with the propane tank mounted at the back of the driver. The tanks, that look much like beer kegs, need to be replaced periodically since they have a limited lifespan. Forklift operators must always use care when handling propane tanks. Compressed gases are dangerous, particularly because the gas is flammable. Utilize caution when replacing and removing propane tank to prevent being injured.
1 If there is a need to replace the propane tank, the first step is to stop the lift truck, then turn off the tank valve. The lift truck should be left on until the engine dies. This procedure burns off the gas in the transfer hose which connects the engine and the tank. Before taking the next steps, put on the correct safety equipment, such as insulated gloves made of either neoprene or leather. It is important for you to protect your skin from contact with the compressed gas, which is extremely cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When putting in a new tank, reattach the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 You can check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas will cause bubbles to foam around the value. If this occurs, inspect the connection hose at the nut and the valve area. The connecting nut should be re-tightened if you detect any leaks in the valve area, and after that do the leak inspection process over again. Persistent leaks mean that both the nut and connecting hose should be replaced. However, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. Then you can start the lift truck and resume operating.